Outsmart
 delco or distributor on the engine , especially outsmart charcoal or 
charcoal delco distributor who runs a thing that is not too difficult . Simply use charcoal as a substitute for charcoal delco tespen exhausted and very durable ( I have proved myself) . Otherwise there could also use charcoal flashlight batteries .The experience I got at the time was in Thamrin street . Car
 engine suddenly died suddenly and while in the starter will not turn on
 , that there must be many causes of this condition can occur . A
 good friend , Laek Marbun ( deceased ) , who then volunteered to help 
fix my car , he immediately predicted that the problem lies in the 
depleted delco charcoal . Chances like this could happen when the car has aged more than 5 years .From
 the above experience , it never hurts to always carry screwdrivers 
tespen (mains voltage 220 
volts ) into the car 's toolbox . If it turns out there is no screwdriver tespen , charcoal used batteries can also be used .1 . Delco car or engine distributor .
2 . Tespen screwdriver which will be used as a cannibal , to repair delco or distributor .
3 . Clean up the middle , where charcoal .

4 . Shape the ends to be tied tespen charcoal per tespen . Cut per taste , and at the end of the cut parts per widened
 
 
5 . Cut per tespen , widen the edges . to fit , when inserted kelubang delco and charcoal not easily be separated from the delco distributor .

6 . Position charcoal tampaik like in the picture . remember , the position of charcoal flexible , can be in and out of the light .
7 . Position charcoal very lightly , to move in and out .

 
8 . Position charcoal very lightly , to move in and out .
volts ) into the car 's toolbox . If it turns out there is no screwdriver tespen , charcoal used batteries can also be used .1 . Delco car or engine distributor .
2 . Tespen screwdriver which will be used as a cannibal , to repair delco or distributor .
3 . Clean up the middle , where charcoal .

4 . Shape the ends to be tied tespen charcoal per tespen . Cut per taste , and at the end of the cut parts per widened
 
 5 . Cut per tespen , widen the edges . to fit , when inserted kelubang delco and charcoal not easily be separated from the delco distributor .

6 . Position charcoal tampaik like in the picture . remember , the position of charcoal flexible , can be in and out of the light .
7 . Position charcoal very lightly , to move in and out .

8 . Position charcoal very lightly , to move in and out .
 
 
 
 
 
 
 
 
 
 
 
 



